Skip to content
Brant Hills Garage Door Co.Request a visit
Open 24/7(289) 816-6526Call now
Gloved person holding a black strip along the side of a sectional garage-door opening — Garage Door Perimeter Weatherstrip, Burlington

Plan ahead Repairs · Burlington

Garage Door Perimeter Weatherstrip

Dry leaves keep appearing in the same corner inside the garage, and this fall there were mouse droppings along the wall beside the door. When you look, the corner where the top and side strips meet is wide open.

Call now · open 24/7(289) 816-6526

Request a visit

In plain words

When the work is finished you have a door that closes against a soft, continuous line of contact on both sides and across the top. From inside with the lights off there is no daylight at the edges; from outside, the new stop matches the trim colour. The door moves through its full travel without the fin catching or squealing. You are told what profile, colour and lengths were fitted, so a match is simple later, and shown the few habits that keep the seal supple: no paint on the fin, a silicone wipe before freezing rain, and slush kept off the bottom of the jambs.

Sound familiar?

The new door went in last year and looks perfect, but the old wooden stop and its tired seal were left in place. Along the top there is a gap you could slide a finger into, and the cold pours through it.

How the visit goes

Garage Door Perimeter Weatherstrip · Burlington

How the visit goes

Technician reaching up with a drill at the vertical track of a black-framed glass-panel garage door, beside a blue ladder.
  1. 1

    Trim, cladding and where water gets behind

    The seal shares the jamb with brickmould, siding, capping and old caulking, and water that gets behind any of them ends up in the wood the strip is nailed to. The technician follows the joint between stop and trim looking for cracked or missing caulk, capping that funnels water down the jamb face, and gaps at the sill where meltwater collects. These are small things to correct while the old strip is off and the surface is bare, and they are what stop the fresh wood from going the way of the old. Anything larger, such as damaged siding, is pointed out for a separate decision.

  2. 2

    Setting the fin against the door

    Getting the fin's contact right is the heart of the work. The technician holds each length against the closed door and adjusts it until the fin bends toward the door just enough to seal without pushing back. A fin set too far off leaves a standing gap that shows as daylight; one set too hard drags the door, folds under on the way down and wears through well before its time. Contact is checked at several points along each side, since a jamb is rarely dead straight, and the fastener positions follow the door face rather than the wood behind it.

  3. 3

    Keep paint off the fin

    When the trim is next painted, the flexible fin stays bare. Paint fills the flexible material and stiffens it, and a stiff fin cracks well before its time once the cold takes hold. If the rigid part of the stop is wood, it can be painted, but with the brush kept off the fin or the fin masked. One-piece vinyl stop needs no paint at all and simply washes clean. This single habit is the difference between a seal that stays soft for many years and one that fails early, and it is the most common cause of early failure the technician sees.

In the van

  • Vinyl stop moulding with integral seal
  • Jamb repair lumber or PVC trim
  • Exterior screws and weatherproof staples
  • Flat bar, hammer and nail set
  • Galvanized or stainless trim nails

What affects the quote

  1. 1

    Trim, brickmould and caulking

    Re-caulking the joint between stop and trim, or dressing capping that channels water down the jamb, is small work done while the surface is bare and is listed on its own line.

  2. 2

    Removing the old stop and paint build-up

    Lifting a wood stop that has been painted for decades, scraping old adhesive and knocking down paint ridges takes longer than pulling a loose fin, and the time shows in the quote.

  3. 3

    Fin on the existing stop or a one-piece vinyl stop

    Nailing a new fin to a sound wood stop uses less material than replacing the stop with a one-piece vinyl moulding, which costs more as a part but needs no paint and does not rot.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 816-6526

Garage Door Perimeter Weatherstrip: questions

Advice · (289) 816-6526

What colours does perimeter weatherstrip come in?

Standard ranges cover white, almond, brown, grey, black and a sandstone or clay tone, which between them match most trim, garage door and brickmould colours. The technician brings the colour that suits your trim once you describe it or send a photo. A one-piece vinyl stop is coloured through, so it does not show scratches, and a fin on a painted wood stop can be matched to the paint.

Why should the seal only touch the door lightly?

The fin is meant to bend against the door with a small, even deflection. That is enough to seal, and it lets the fin spring clear as the door lifts. Pressed hard, it drags on the door face, folds under on the way down, squeals and wears through well before its time, and it adds load to the opener. Set too far off, it leaves a standing gap. The light touch is the setting that lasts.

How should I look after the new seal?

Four times a year, check for daylight from inside with the lights off and press the fin to feel that it is still soft. Wipe the seal with a damp cloth to clear grit and salt, keep paint off the fin, apply a silicone wipe before winter, and keep slush and bins away from the bottom of the jambs. Press any lifted corner back and call if a length has come loose.

Halton, Ontario

Burlington information

Town
Burlington, Halton, Ontario
In business
22 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

47%

Homes of every age. About 47% of homes in Burlington were built in 1980 or earlier, according to the 2021 Census.

A blend of older and newer homes usually means a blend of expectations too: keeping an original door running as long as sensible, or bringing a builder-grade door up to a quieter standard. Both are worthwhile, and the choice is explained at the door with the options side by side.

50%

A mix of homes. Single-detached houses make up about 50% of homes in Burlington (2021 Census).

Where housing is mixed, the doors are mixed as well: wide insulated doubles, narrow singles in rows and the occasional rolling door on a small commercial unit at the corner. Spring type, cable length and opener strength are matched to each door individually.

Source: Statistics Canada, 2021 Census of Population

Open Burlington in Google Maps

Open 24/7

Request a visit

Dry leaves keep appearing in the same corner inside the garage, and this fall there were mouse droppings along the wall beside the door.

Call now · open 24/7(289) 816-6526
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 22 years in business